共搜索到7808条信息，每页显示10条信息，共781页。用时：0小时0分1秒268毫秒
Leilei, FENG Wei, et al. Microstructure and properties of C/C-SiC composites prepared by reactive melt infiltration at low temperature in vacuum[J]. Ceramics International, 2020, 46(6): 8469-8472. [9......
temperatures for different time in a vacuum furnace. The intercept line method was used to measure the average grain size of foil specimens. The material parameters and correlated annealing conditions......
100 Pa by a vacuum pump, the furnace was filled with Ar (99.99%) until total pressure reached 0.11 MPa. Thirdly, the furnace was heated until the temperature reached 1400 °C with CO (99.99......
reported activated carbon and CNT sandwiched rGO film via vacuum filtration. The SCs based on resulting films exhibited a specific capacitance of 101 F/g. Comparing with other film preparation methods......
and polyvinylidene fluoride in a mass ratio of 7:2:1 and then dispersed into 1-methyl-2-pyrrolidinone to mix evenly. The slurry was passed onto the copper foils. After being dried in vacuum at 80 °C for 24 h......
] ZHANG Ping, SONG Ai-li, FANG Yu-xin, YUE Xiu-jie, WANG You-qiang, YU Xiao. A study on the dynamic mechanical behavior and microtexture of 6082 aluminum alloy under different direction [J]. Vacuum, 2020......
Experimental Two alloys with compositions of Al-7Si- 0.3Mg and Al-7Si-0.3Mg-0.2Er (wt.%) were cast using ZG-0.025 vacuum induction melting furnace and the detailed compositions are presented in Table 1......
stirred for 24 h. Subsequently, the obtained slurries were coated on Cu foils followed by vacuum drying at 60 °C for 6 h. The copper foils were punched into a wafer and dried again. CR2032-type......
cut from a commercially pure Ti plate, annealed in vacuum at 650 °C for 1 h, and then cold-rolled to 40% thickness reduction. TEM specimens were then cut from the transverse section......
In the present investigation, the alloy was manufactured by in a 25 kg vacuum induction furnace and cast into tensile samples. The nominal chemical composition of the as-cast alloy 625 (in mass fraction......
