共搜索到19449条信息，每页显示10条信息，共1945页。用时：0小时0分1秒228毫秒
transverse and longitudinal strains are recorded using a strain gauge during the loading process. The loading rate per stage is 100 N/s. Test flow chart is shown in Figure 6. The grading loading creep test......
, et al. Study on preparation of phosphogypsum-based filling matrials and its leaching rate of harmful substances[J]. Industrial Minerals & Processing, 2017, 46(5): 39-43. [33] GOUGAR M L D, SCHEETZ......
is to increase slowly and then sharply increase, as shown in Figure 10(c). The growth rate of the elastic modulus curve starts to increase dramatically at the 15th measuring point, and the curve reaches......
room temperature to 1100 °C with a heating rate of 10 K/min. Phase analysis of samples was tested by X-ray diffraction analysis (XRD, Rigaku D/MAX-RC) at 2θ=10°-120° using Cu Ka radiation. The chemical.... Influence of heat treatment on microstructures and magnetic properties of Fe-based soft magnetic composites prepared by co-precipitation method [J].Journal of Magnetism and Magnetic Material,2019, 476......
tensile test were prepared according to the ASTM E8M-04 standard, and the tensile tests were done at a strain rate of 1 mm/min. The micro- hardness tests of the specimens were performed with a load......
): 1928-1937. [38] SHAO X H, ZHENG S J, CHEN D, et al. Deformation twinning induced decomposition of lamellar LPSO structure and its re-precipitation in an Mg-Zn-Y alloy[J]. Scientific Reports, 2016, 6(1..., BEYERLEIN I J, MCWILLIAMS B A, et al. Strain rate and temperature sensitive multi-level crystal plasticity model for large plastic deformation behavior: application to AZ31 magnesium alloy[J......
ratio respectively. The amplitude ratio by which reflects the contrast of the sound intensity is the rate of the amplitude of the enhanced signals to that of the original noisy signals. According......
contraction rate estimation from dynamic antral scintigraphy using Hilbert-Huang transform [J]. Computers in Biology and Medicine, 2020, 117(2): 103560. DOI: 10.1016/j.compbiomed.2019.103560. [51] SUSANTO......
] RUIZ E, ACHIM V, SOUKANE S, et al. Optimization of injection flow rate to minimize micro/macro-voids formation in resin transfer molded composites[J]. Composites Science and Technology, 2006, 66(3/4......
Technology, 2018, 262: 221-231. [10] HURON E, SRIVATSA S, RAYMOND E. Control of grain size via forging strain rate limits for R’88DT[C]// POLLOCK T M, KISSINGER R D, BOWMAN R R, et al. Superalloys. Warrendale......
