共搜索到1891条信息，每页显示10条信息，共190页。用时：0小时0分0秒846毫秒
of length 250 mm and diameter 60 mm are cast by quenching semisolid slurry in the stated metal mould. For relative comparison of microstructures, some of the semisolid cast billets are also reheated up......
. The counterpart discs with an external diameter of 54 mm were made of SAE1045 steel (Fe-0.46%C-0.6%Mn-0.035%P-0.03%S) and had a hardness of HRC 50 after induction quenching. Wear tests were performed......
and efficient gas release of blowing agent. Cell wall material strengthening might be another reason due to a lower foaming temperature and quenching the mold in water rather than cooling in air. 3.4 Elastic......
S, MORI K. Hot stamping and press quenching of ultrahigh strength steel sheet using resistance heating [J]. Key Engineering Materials, 2007, 344: 309-316. [11] MORI K, SAITO S, MAKI S. Warm and hot......
images of the experimental alloys solutionized at 300 °C for 12 h and 450 °C for 12 h, and followed by water quenching. Based on the EDS results of the solutionized alloys (Table 3), the intermetallic......
. Subsequently, they were quenched to room temperature. After the quenching, all samples were kept at room temperature for 24 h and then aged at 120 °C for 24 h. Tensile tests were carried out......
]. Thus, the Ni5Al3 can only be obtained by quenching NiAl of the corresponding composition and aging the resultant martensite at T<973 K [22,23], which is totally different with the SHS joining......
→ solution treatment in a salt bath at a temperature of 555 °C for 2 min → water quenching → pre-aging at 80 °C for 12 h + 14 d natural aging (T4P state). The mechanical properties of the alloy sheet at T4P......
levitation and splat-quenching [9], have been successfully applied to the preparation of Cu-Cr alloys. Enhanced performance is thus achieved through microstructure optimization, which can to a large... into the gap. The gap width was reported to be broad. For example, a recent experimental investigation on Cu-Cr alloys prepared by electromagnetic levitation and splat quenching verified the occurrence......
in thickness through hot rolling and cold rolling processes. The sheets were then subjected to a simple T8 aging treatment after solid solution treatment at 520 °C and quenching in water at room temperature......
