共搜索到17661条信息，每页显示10条信息，共1767页。用时：0小时0分0秒644毫秒
is a strong non- equilibrium process, in which ions transfer their kinetic energy to the growing film and heat in an atomic level. This process differs significantly from conventional heating because......
passivation layers[11]. Therefore, in order to increase the heat efficiency, the passivation layers should be thinned as possible or removed. However, it should be noted that the above- mentioned heater......
, such as ion-exchangers, medical and chemical application as absorbents and polymer-supported catalyst[1-3]. Especially, there are strong demands for highly crosslinked polymer beads with superior heat......
tertiary creep is from weak to heat resin. Thermoplastic resin is fractured right away when load capacity of reinforcing fiber is exceeded. Figure 5 shows the change in creep state with compression......
material that is widely used in a variety of applications due to its durability, high compressive strength, high heat resistance, high fire resistance and high chemical resistance. Commercial uses......
[J]. 重庆建筑大学学报, 2008, 30(2): 132-134.ZHANG Zhi-qiang, HU Ling. Testing Method and Heat insulating principle of the thermal insulation coatings for external wall, Journal of Chongqing Jianzhu University...研制[J]. 现代涂料与涂装, 2003(1): 6-9.GUO Nian-hua. Development of polyurethane modified chloroacylic resin solar-heat reflective paint[J]. Modern Paint & Finishing, 2003(1): 6-9. [15] GB 6566-2000. 建筑材料放......
after the die is opened. During this process, the cooling occurs in the ladle, shot chamber and runner and die cavity. There is a high heat-transfer coefficient among the liquid metal and the shot...]. Journal of Materials Processing Technology, 1996, 57(3-4): 259-265. [2] HELENIUS R, LOHNE O, ARNBERG L, LAUKLI H I. The heat transfer during filling of a high-pressure die-casting shot sleeve [C......
, heat was applied until a constant temperature was reached, and then the scraper was used to remove the old surface film so that a fresh melt surface could be obtained. The melt was left in the furnace......
process was carried out using the metal forming code DEFORM 3D. 3D plane strain and heat transfer models were used. The mold and plunger were assumed as rigid body. The billet material used......
properties of melt spun or heat treated ribbons[8-9]. However, there was seldom reports on the extrusion behavior of powder particles during consolidation. In the present Al-18%Si alloy powders, a broad......
