共搜索到839条信息，每页显示10条信息，共84页。用时：0小时0分0秒357毫秒
composite laminates and metal; the materials must be joined. Two conventional means of joining are available: mechanical joining and adhesive bonding. Both methods have critical disadvantages. A novel.... The surface modified metal can be bonded with composite laminates to form a Comeld~(TM) joint. These joints can be described as a combination of mechanical fastening and adhesive bonding. This paper......
fluoride(PVDF) adhesive, acrylic adhesive, Li0.5CoO2 and LiC6. The safety test was carried out on 063048 prismatic lithium-ion batteries. The results show that PVDF adhesive and conductive carbon black exhibit better thermal stability compared with acrylic adhesive and acetylene carbon black. The total reaction heat of each influencing factor responsible for the thermal stability of lithium-ion......
time and different cutting speed on adhesive wear were analyzed.The conclusion will provide useful references for the optimization of cutting parameters and the improvement of the tool life.关键词:......
changed from mild abrasive wear and adhesive wear to abrasive wear failure at 500 °C, and then transferred to adhesive wear and mild oxidation wear at 700 °C. For SKD11 hardened steel, the primary wear mechanism changed from delamination wear to abrasive wear and then transferred to plastic deformation and fatigue wear, accompanied by adhesive wear and tribo-oxidation wear.关键词:......
steel at the friction temperature of 450°C. A mild adhesive wear mechanism was found for the electro-brush plating Ni-P coating tested at 450°C, whereas for the 20CrMo steel at the same temperature a mixed adhesive and abrasive wear mechanism was observed.关键词:......
of coating fiber was studied. Different water-transmitting coating fibers were prepared by coating fiber using coating material with different mass proportions of additives to adhesive. And the coating materials were made from three kinds of inorganic clays as additives respectively and polyvinyl alcohol (PVA) as adhesive. Furthermore, the surface morphology and water-transmitting capacity......
fraction of Ti2 AlN.The wear mechanisms of the pairs are adhesive wear and the wear debris mainly comes from the contacting nickel-based superalloy.The intergranular fracture and the cracking of the phase boundary in the lamellar structure are the wear mode of TiAl alloy.The wear mode of TTC is phase boundary fracture and adhesive spalling.The abrasive resistance of TTC is slightly higher than......
microscopy.Grain orientation and phase were determined using X-ray diffraction.The residual stress of the coating was studied by glancing incidence X-ray diffraction.The adhesive force of the coating was measured... of delamination.The adhesive force of the monolayer and multilayer was about 50 and 43 N,respectively.The interfacial reaction between the substrate and the layer occurred and a new WIr phase was found due......
and Springer-Verlag GmbH Germany, part of Springer Nature 2018 Abstract: The key parameters of the adhesive layer of a reinforcing patch are of great significance and affect the ability to suppress crack propagation in an Al–Li alloy patch-reinforced structure. This paper proposes a method to determine the key parameters of the adhesive layer of adhesively bonded joints in the Al–Li alloy patch-reinforced......
of bonding bridge change from the adhesive to the cohesive and raises the strength of sodium silicate-bonded sand.关键词:......
