共搜索到18653条信息,每页显示10条信息,共1866页。用时:0小时0分0秒451毫秒
Null 包大杰1 (1.上海柴油机厂,上海,200432) 摘要: 问:何谓钢铁中全碳量(总碳量)和游离碳?答:碳在钢,铁中主要以化合状态和游离状态存在.在钢中主要以铁的碳化物如:Fe3C,Fe23C6等以及与某些合金元素的碳化物如:Mn3C,WC,TiC,MoC,VC,Cr3C2,Cr6C2等形式存在,统称为化合碳,钢中很少有游离碳.在铁中碳除以化合碳存在外,还以游离状态(石墨碳)存在,而且是主要形式.但是在白口铁中则多以碳化铁(Fe3C)形式存在. [全文内容正在添加中] ......
; molten salt electrolysis; electrical conductivity; NaF; AlF3; Al-Zr alloy 1 Introduction Al-Zr alloys as one of the new structural materials are used in various fields, such as aerospace, military, nuclear reactions and atomic energy [1-4]. Cryolite- zirconia can be used as electrolyte for producing Al-Zr alloy by molten salt electrolysis. Compared with the common methods of preparing Al-Zr master......
to the micro range. Two different foils out of the Al-Zr alloy with a thickness of about 15 μm were manufactured using a magnetron-sputtering process by applying substrate temperatures of 310 K and 433 K...Trans. Nonferrous Met. Soc. China 22(2012) s268-s274 Drawability of thin magnetron sputtered Al-Zr foils in micro deep drawing Gerrit BEHRENS1, Julien KOVAC2, Bernd 2, Frank VOLLERTSEN1, Heinz-Rolf......
Al-Zr(CO3)2体系反应合成复合材料的反应机制及动力学模型 赵玉涛, 孙建祥, 戴起勋, 程晓农, 林东洋 (江苏大学 材料科学与工程学院, 镇江 212013) 摘 要: 开发了Al-Zr(CO3)2体系熔体反应法合成新型(Al3Zr+Al2O3)p/Al复合材料, 研究了Al-Zr(CO3)2体系的反应热力学, 反应动力学及反应机制. 结果表明: Al-Zr(CO3..., 且合成过程前期(反应3min前)主要受化学反应控制, 合成过程后期(反应10min后)主要受扩散控制. Al-Zr(CO3)2体系中关键反应ZrO2与Al按反应-扩散-破裂机制进行, 并建立了反应原理图, 反应动力学模型和反应时间的动力学方程. 关键词: Al-Zr(CO3)2体系; 反应机制; 动力学模型; 熔体反应法; 原位复合材料 中图分类号: TB331 文献标识码......
and development of ultra-high strength aluminum alloy containing zirconium[J]. Journal of Aeronautical Materials, 2002, 22(4): 56-61. [3] 张映新. Al-Ti和Al-Zr中间合金组织遗传性对铝合金铸造组织的影响[J]. 轻合金加工技术, 1998, 26(11): 11-13.ZHANG Ying-xin. Effect of structures heredities of Al-Ti and Al-Zr master alloys on casting structures of aluminum alloys[J]. Light Alloy Fabrication Technology, 1998, 26(11): 11-13. [4] 余爱武, 杨成刚, 刘奋成......
), it is demonstrated that the conductivity depends on the content of Zr in the Al solid solution which is the minimum after holding at 450 °C for 3 h. On the other hand, the hardness of the alloy is mainly... conditions, rolling regime and, especially, the heat treatment cycle. According to the experimental results of TACER et al [12], the conductivity of an Al–0.25%Zr (mass fraction) alloy reaches the peak......
电解Al-Zr母合金的热力学曹大力1,石忠宁1,王吉坤2,邱竹贤11. 东北大学材料与冶金学院2. 云南冶金集团总公司摘 要:简要介绍了Zr在铝及铝基合金中的作用,提出利用氧化锆,氧化铝直接在电解槽中电解Al-Zr母合金的工艺方案;从热力学角度对该方案进行了分析,并利用Miedema模型对锆在铝中的活度系数进行了计算·结果表明:在活性阳极电解条件下(1223K),锆与铝可以共同析出,锆在铝中的活度系数接近1;氧化锆在电解液中的溶解度约0·55%;可以在电解槽中直接生产锆的质量分数为2%左右的Al-Zr母合金·关键词:Al-Zr母合金;电解;热力学;ZrO2;活度系数;溶解度;......
The Strengthening of Cu-15Ni-8Sn Alloy WANG Ming-Pu1,WANG Yan-hui1,HONG Bin1 (1.School of Material Science and Engineering, Central South University, Changsha China) 摘要:The microstructure, property and relation between them of Cu-15Ni-8Sn alloy are studied by means of TEM and the measurement of hardness. The results show that γ '' metastable phase strengthens alloy because of its ordering......
文章编号:1004-0609(2010)S1-s0550-05 Ti-75合金的正交设计与强化机制 那晓菲1,王卫民2,李 雷2 (1. 西部金属材料开发有限公司,西安 710016;2. 西安赛特金属材料开发有限公司,西安 710016) 摘 要:采用正交设计的方法,通过测定试验合金的力学性能,点阵常数,弹性模量,系统研究了Ti-Al-Mo-Zr合金系中单一合金元素Al,Mo,Zr和Al-Mo,Al-Zr,Mo-Zr合金元素之间的交互作用对力学性能和显微组织的影响,并给出了合金成分与力学性能间的定量关系式. 关键词:Ti-75合金;正交设计;强化机制 中图分类号:TF 804.3 文献标志码:A Orthogonal design and strengthening mechanism......
工艺参数对Al-Zr中间合金中初生Al3Zr相的影响李飞,朱庆丰,李磊,崔建忠东北大学材料电磁过程研究教育部重点实验室摘 要:以Al-K2ZrF6为反应体系,采用Al热还原法,研究了不同工艺参数对Al-Zr中间合金凝固过程中初生Al3Zr相的形貌,尺寸,数量及分布状态的影响.结果表明:随着熔体反应温度的增加,Al3Zr晶体的形貌由小块状逐渐长成长条状,尺寸增加,数量减少;当温度低于1 000℃,晶体呈现小块状;温度高于1 000℃时,晶体呈现长条状;温度为1 000℃时,晶体呈现块状和长条状的混合态.与使用铁模相比,采用耐火材料模时,Al3Zr相尺寸增大,数量减小.随着K2ZrF6加入量的增加,Al3Zr相的体积分数增多,尺寸更细小,分布更均匀.关键词:Al-Zr中间合金......