六辊冷连轧机板形前馈控制模型的研究
来源期刊:钢铁2009年第12期
论文作者:梁勋国 王业科 赵吉成 王国栋
文章页码:62 - 66
关键词:六辊冷连轧机; 板形; 前馈控制; 模型
Key words:six high tandem cold rolling mill; flatness; feedforward control; model
摘 要:冷连轧过程中,轧制力波动对板形的影响很大,需要采用弯辊力进行实时的补偿。针对六辊冷连轧机,分别研究了仅用工作辊弯辊和采用工作辊与中间辊弯辊相结合的板形前馈控制模型。实际控制效果表明,这两种板形前馈控制模型都能有效消除轧制力波动对板形产生的不利影响;采用工作辊弯辊的板形前馈控制模型只能控制由于轧制力波动产生的二次板形,而对四次板形几乎不产生影响;而采用工作辊与中间辊弯辊相结合的板形前馈控制模型则对二次和四次板形均具有很强的控制能力。
Abstract: Rolling force variation will affect the strip flatness during continuous cold rolling.Therefore,real-time bending force compensation would be in great needs.Two flatness feedforward control models for six high tandem cold rolling mill were investigated.The work roll bending was applied in both kinds of control models,while the intermediate roll bending was employed additionally in the second control model.Control results show that negative effects of the rolling force variation on strip flatness can be reduced efficiently in both control models.Quadratic component of strip flatness which is caused by rolling force variation can be eliminated by employing the work roll bending compensation model.But almost no contribution could be made to the elimination of quartic component.However,for work roll and intermediate roll bending compensation model both quadratic and quartic components of strip flatness can be controlled effectively.
梁勋国1,王业科1,赵吉成1,王国栋2
(1.重庆市中冶赛迪工程技术股份有限公司冷轧事业部
2.东北大学 轧制技术及连轧自动化国家重点实验室,沈阳l10004)
摘 要:冷连轧过程中,轧制力波动对板形的影响很大,需要采用弯辊力进行实时的补偿。针对六辊冷连轧机,分别研究了仅用工作辊弯辊和采用工作辊与中间辊弯辊相结合的板形前馈控制模型。实际控制效果表明,这两种板形前馈控制模型都能有效消除轧制力波动对板形产生的不利影响;采用工作辊弯辊的板形前馈控制模型只能控制由于轧制力波动产生的二次板形,而对四次板形几乎不产生影响;而采用工作辊与中间辊弯辊相结合的板形前馈控制模型则对二次和四次板形均具有很强的控制能力。
关键词:六辊冷连轧机; 板形; 前馈控制; 模型