CuxSiy改性C/C-SiC复合材料的制备及其性能
来源期刊：中国有色金属学报2010年第12期
论文作者：肖鹏 周伟 李专 熊翔
文章页码：2344 - 2350
关键词：CuxSiy改性C/C-SiC复合材料；力学性能；摩擦磨损性能
Key words：CuxSiy modified C/C-SiC composites; mechanical property; tribological property
摘 要：以针刺整体炭毡为预制体，采用化学气相渗透法(CVI)增密制备C/C多孔体，然后采用反应熔体浸渗法(RMI)，将Cu与Si同时熔渗进C/C坯体中制备CuxSiy改性C/C-SiC复合材料。研究CuxSiy改性C/C-SiC复合材料的组织结构、力学性能和摩擦磨损性能，并与C/C-SiC复合材料进行对比。结果表明：CuxSiy改性C/C-SiC复合材料的弯曲强度和冲击韧性略低于C/C-SiC复合材料的；采用30Cr钢作对偶时，CuxSiy改性C/C-SiC复合材料的摩擦因数约为0.24，线磨损率小于4 μm·side-1·cycle-1，均与C/C-SiC复合材料的相近，但其摩擦表面温度降低约50 ℃；以自身材料作对偶时，CuxSiy改性C/C-SiC复合材料的摩擦磨损性能略低于C/C-SiC复合材料的。
Abstract: CuxSiy modified C/C-SiC composites were fabricated by infiltrating Cu and Si into C/C porous performs that were prepared by chemical vapor infiltration (CVI). The microstructure, mechanical and tribological properties of CuxSiy modified C/C-SiC composites were investigated and compared with those of C/C-SiC composites. It is shown that the flexural strength and impact toughness of CuxSiy modified C/C-SiC composites are a little lower than those of C/C-SiC composites. With 30Cr steel as couple parts, the friction coefficients of CuxSiy modified C/C-SiC composites are about 0.24 and their linear wear rates are less than 4 μm·side-1·cycle-1, which are both close to those of C/C-SiC composites. But the temperature of friction surface of CuxSiy modified C/C-SiC composites is reduced by about 50 ℃. With the same composites as couple parts, the tribological properties of CuxSiy modified C/C-SiC composites are a little worse than those of C/C-SiC composites.
